規格
| Valve body material | Cast Iron, Ductile Iron |
|---|---|
| Disc Materials | Ductile Iron, Aluminium Bronze, Stainless Steel |
| spring materials | Stainless Steel |
| shaft materials | Stainless Steel |
| seat ring materials | EPDM, NBR |
| Nominal valve connection size | DN40 to DN600 |
| Pressure class / nominal rating designation | Class 150 to Class 2500 |
| Design standards | API 6D |
| Face-to-face dimensional standard | ASME B16.10 |
| Flange standards | ANSI B16.5, ANSI B16.47 |
| butt weld ends | ANSI B16.25 |
| Inspection and pressure-test standards | API 598 |
應用與選型指引
Select this execution where the check valve sits close to equipment that hammer would damage - pump discharges, high-rise risers, or long lines with fast-closing duty - and size by the nominal diameter band DN40 to DN600 against the line class up to Class 2500. Confirm the seat ring compound (EPDM or NBR) against the medium temperature, and match the end face standard to the mating flange or weld preparation. Where noise and surge are secondary and cost leads, a conventional swing check remains the simpler choice.
常見問題
What makes a swing check valve "non slam"?
A conventional swing check disc travels a wide arc and lands only after reverse flow has developed, which produces the slam. The non slam execution adds a spring acting on the disc so closure begins as forward flow decays, before significant reverse velocity builds. The benefit is lower surge pressure and quieter operation, at the cost of a spring component and slightly higher cracking pressure.
Which end connections does this execution cover?
The benchmark page declares flanged faces to ANSI B16.5 and B16.47 and a buttweld dimension to ANSI B16.25, so the valve installs into standard flanged lines and welded lines alike. Match the face standard and rating to the mating pipe class rather than assuming interchangeability across the DN40 to DN600 range.
What information is needed to quote a non slam swing check valve?
Nominal size inside the DN40 to DN600 band, pressure class up to Class 2500, medium and temperature (to fix the EPDM or NBR seat ring), end connection (flanged per B16.5/B16.47 or buttweld per B16.25), and the installation orientation. Those points let the execution, seat compound and face standard be confirmed in one pass.
訂購與文件
文件
請在詢問時一併說明您需要的文件組合——此結構的常見項目（材質證明、按所列檢驗標準的測試報告、尺寸圖）將於報價時確認並隨附供應。
報價
可直接報價的詢問應說明：公稱口徑與壓力額定、閥體與閥座材質偏好、端部連接、操作方式，以及含溫度的使用介質。本頁的典型值為基準參考範圍；具有約束力的數值於報價時確認。
樣品與供應
供應條件、訂購數量與交期按訂單議定——請在詢問時說明目的地國家與所需時程。
儲存與運輸
閥門儲存時應保護閥座與密封件免受紫外線、臭氧與變形影響，安裝前保留端面保護蓋；彈性體或 PTFE 閥座結構應避免長期戶外存放——閥座材料在陽光直射與冰凍條件下老化最快。